Drill stand 0 90 degrees drill chuck 38 43mm drill holder adjust Iron base woodworking bench BG 6117 for Power Tool Accessories

Drill stand 0 90 degrees drill chuck 38 43mm drill holder adjust Iron base woodworking bench BG 6117 for Power Tool Accessories
  • Продавецmasalgibi.info
  • Список ценUS $20.03piece
  • Продажная ценаUS $20.03piece
  • ДоставкаБесплатная доставка
  • Рейтинги3,3 (344)

Oписание продукта

The new double-headed veneer cutter is a product that has undergone several improvements; It is a cutting tool powered by electric and pneumatic drills; It can cut metal sheets up to 2 mm (including steel, copper, aluminum, stainless steel board);When cutting a blunt cut for the other end to continue cutting, regardless of cutting cheeks or surfaces, can easily cut out a variety of straight lines, curves, arcs or other irregular lines and shapes.
When coupled with thin plate hole cutter can cut 55 mm -260 mm standard round hole;This product is light weight, small size, easy to operate and other characteristics, is an Perfect tool for auto repair, sheet metal production and new product development.
Cut a good helper; As long as with a drill you can freely cut any thin metal, any shape.
Operation requirements and replacement parts: knife blade diligent refueling, especially cutting aluminum is particularly important;first electric drill, after cutting, the end of the exit after the first off drill;Cutting cutter bar when the cut must be cut perpendicular to the workpiece to be cut, in case hard to break the broken head.
Arbor replacement: Open the protective cover, remove the locknut, loosen the set screw, remove the arbor with pliers, reinstall the arbor, and tighten the screws. Knife holder replacement: Screw out the compression cap counterclockwise, put on a new knife holder.

Sheet metal opener instructions
When equipped with a thin plate hole opener, first insert the front end of the drill and the cutter into the hole of the hole cutter, connect the cutter to the drill and lock it firmly, and then tighten the three sticks and the head screws of the rack , So as to prevent the hole of the hole opener from slipping. Insert the rule bar left-to-right into the square hole of the shelf with the left-to-right positioning pin upward.
Finally adjust and tighten the tight-top screw according to the size of the arc to be cut, In ord

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()